SConnect
Installation and Test

Follow the onscreen instructions to install SConnect in your browser. This page installs SConnect host 2.13.0.0 with versions 1.6.10.7, 1.7.10.7 and 1.8.10.8 of the PKCS11 add-on and versions 1.4.1.1, 1.5.1.1 and 1.6.1.1 of the WebSigner add-on.

Important: If your signing portal also uses SConnect then please also install SConnect host 2.15.1.0 for SWIFT. Download the .zip file, extract it then run sconnect-host-v2.15.1.0-swt.exe. This version replaces SConnect host 2.13 and works on SWIFT portals and on third-party portals that use SConnect.

A message SConnect installed successfully will show beneath this frame at the end of the installation. If you do not see such message please verify the installation requirements with help of your system administrator then refresh this page to resume the installation. Refer to the SConnect installation page and the Browser configuration page on the 3SKey website for details on installation requirements.

• Verify that you are allowed to download and execute an installation file from this page. If your security policies prevent you from executing the installation file directly from the browser, please download and execute it from a local folder then refresh the page to resume the installation.

• An installation or update over an existing or partial installation may fail. This can also happen if another non-SWIFT version of SConnect is already installed. If you encounter an installation or validation error message during the installation please perform a clean installation as follows: Uninstall SConnect IE or SConnect Host from the Windows Control Panel. For browsers other than Internet Explorer, remove the SConnect extension in the browser menu > Add-ons > Extensions. Then restart your browser and retry the installation.

• Browser support: Refer to the SConnect installation page on the 3SKey website to learn what browsers are supported with your service, and whether specific settings are required.